The Evaluation of Quality Parameters and Drying Efficiency of Button Mushroom in Hybrid Microwave-Hot Air Dryer

Document Type : Original Paper

Authors

1 Department of Biosystems Engineering, University of Kurdistan, Sanandaj, Iran

2 Assistant Professor, Department of Biosystems Engineering, University of Kurdistan, Sanandaj, Iran

3 Assistant Professor, Department of Mechanical Engineering of Biosystems, Urmia University, Urmia, Iran

Abstract

In this study, the button mushroom (agaricus bisporus) as a whole in a combined microwave-hot air dryer in two status of power density: fixed and variable, three levels of initial power density (1.5, 2 and 2.5 W/g) and three levels of hot air temperature (23, 50 and 70 ºC) were dried. Drying efficiency and the final dried product quality (color and rehydration ratio) were evaluated. The highest drying efficiency (44.44%) was obtained with 1.5 fixed power density and 23 °C. The results of color parameters showed that the dried product in constant power density status had better appearance (color) than the variable mode and also increased power density levels and reduced the air temperature increased the color changes and decreased final products quality. Also the dried product with constant power density in compared with variable power density and using the hot air in compared with environmental air had higher rehydration ratio.

Keywords

Abbasi Souraki, B., & Mowla, D. (2008). Experimental and theoretical investigation of drying behavior of garlic in an inert medium fluidized bed assisted by microwave. Journal of Food Engineering, 88(4), 438-449. doi:https://doi.org/10.1016/j.jfoodeng.2007.12.034
Alibas, I. (2007). Microwave, air and combined microwave-air drying parameters of pumpkin slices. LWT-Food Science and Technology, 40(80), 1445-1451. doi:https://doi.org/10.1016/j.lwt.2006.09.002
Andres, A., Bilbao, C., & Fito, P. (2004). Drying kinetics of apple cylinders under combined hot air-microwave dehydration. Journal of Food Engineering, 63(1), 71-78. doi:https://doi.org/10.1016/S0260-8774(03)00284-X
AOAC. (1980). Official method of analysis. (13th ed). Association of Official Analytical Chemists, Washington DC.
Argyropoulos, D., Heindl, A., & Muller, J. (2011). Assessment of convection, Hot-air combined with microwavevacuum and freeze-drying methods for mushrooms with regard to product quality. International Journal of Food Science and Technology, 46(2), 333-342. doi:https://doi.org/10.1111/j.1365-2621.2010.02500.x
Botha, G.E., Oliveira, J.C., & Ahrne, L. (2012). Microwave assisted air drying of osmotically treated pineapple with variable power programmes. Journal of Food Engineering, 108(2), 304-311. doi:https://doi.org/10.1016/j.jfoodeng.2011.08.009
Dondee, S., Meeso, N., Soponronnarit, S., & Siriamornpun, S. (2011). Reducing cracking and breakage of soybean grains under combined near-infrared radiation and fluidized-bed drying. Journal of Food Engineering, 104(1), 6-13. doi:https://doi.org/10.1016/j.jfoodeng.2010.11.018
Hazervazifeh, A. (2012). Designing, manufacturing and evaluating microwave-hot air combination drier. (Unpublished master's thesis), Agriculture College, Urmia University. (in Persian)
Hazervazifeh, A., Moghaddam, P.A., & Nikbakht, A.M. (2016). Microwave dehydration of apple fruit: Investigation of drying efficiency and energy costs. Journal of Food Process Engineering, 40(3), e12463. doi:https://doi.org/10.1111/jfpe.12463
Horuz, H., Bozkurt, H., Karataş, H., & Maskan, M. (2018). Simultaneous application of microwave energy and hot air to whole drying process of apple slices: drying kinetics, modeling, temperature profile and energy aspect. Heat and Mass Transfer, 54(2), 425-436. doi:https://doi.org/10.1007/s00231-017-2152-y
Khoshtaghaza, M.H., Hosseinzadeh, B., Fayyazi, E., & Amirnejat, H. (2016). Prediction of thin layer drying of edible mushroom moisture content by feed forward artificial neural networks method. Iranian Journal of Food Science and Technology, 13(50), 171-182. (in Persian)
Kisselmina, Y.K, Druon, C., Gnimpieba, E.Z., Delmotte, M., Duquenoy, A., & Laguerre, J.C. (2013). Power density control in microwave assisted air drying to improve q`uality of food. Journal of FoodEngineering, 119(4), 750-757. doi:https://doi.org/10.1016/j.jfoodeng.2013.06.044
Kotwaliwale, N., Bakane, P., & Verma, A. (2007). Change in textural and optical properties of oyster mushroom during hot air drying. Journal of Food Engineering, 78(4), 1207-1211. doi:https://doi.org/10.1016/j.jfoodeng.2005.12.033
Li, Z., Raghavan, G. S. V., & Orsat, V. (2010). Temperature and power control in microwave drying. Journal of Food Engineering97(4), 478-483. doi:https://doi.org/10.1016/j.jfoodeng.2009.11.004
Li, Z., Raghavan, G.S.V., Wang, N., & Vigneault, C. (2011). Drying rate control in the middle stage of microwave drying. Journal of Food Engineering, 104(2), 234-238. doi:https://doi.org/10.1016/j.jfoodeng.2010.12.014
Mohebbi, S. (2013). Evaluation of tomato quality parameters with different drying method. (Unpublished master's thesis), Agriculture College, Urmia University. (in Persian)
Noori, M., Kashaninejad, M., Daraei Garme Khani, A., & Bolandi, M. 2012. Optimization of drying process of parsley using the combination of hot air and microwave methods. Electrical Journal of Food Processing and Preservation, 4(2), 103-122. (in Persian)
Rhim, J.W., & Lee, J.H. (2011). Drying kinetics of whole and sliced shiitake mushrooms (lentinus edodes). Food Science and Biotechnology, 20(2), 419-427. doi:https://doi.org/10.1007/s10068-011-0059-9
Sharifian, F. (2012). Modeling and optimizing of Fig drying process using microwave dryer. (Unpublished doctoral dissertation), Agriculture College, Urmia University. (in Persian)
Sharifian, F., Modarres-Motlagh, A., Komarizade, M.H., & Nikbakht, A.M. (2013). Colour change analysis of fig fruit during microwave drying. International Journal of Food Engineering, 9(1), 107-114. doi:https://doi.org/10.1515/ijfe-2012-0211
Sharma, G.P., & Prasad, S. (2006). Optimization of process parameters for microwave drying of garlic cloves. Journal of Food Engineering, 75(4), 441-446. doi:https://doi.org/10.1016/j.jfoodeng.2005.04.029
Torringa, E., Esveld, E., Scheewe, I., Berg, R.V.D., & Bartels, P. (2001). Osmotic dehydration as a pre-treatment before combined microwave-hot-air drying mushrooms. Journal of Food Engineering, 49(2-3), 185-191. doi:https://doi.org/10.1016/S0260-8774(00)00212-0
Zhang, M., Li, C.L., & Ding, X.L. (2005). Effects of heating conditions on the thermal denaturation of white mushroom suitable for dehydration. Drying Technology, 23(5), 1119-1125. doi:https://doi.org/10.1081/DRT-200059145
CAPTCHA Image
Volume 7, Issue 2
July 2018
Pages 213-224
  • Receive Date: 05 September 2017
  • Revise Date: 31 January 2018
  • Accept Date: 23 February 2018